Cyclades AlterPath BladeManager Manuale delle Istruzioni Scaricare il pdf (Pagina 219)

Appendices 205

3. Check that the environment variables are set properly with the printenv command.

4. Enter the

save command.

=> save

5. Enter the net_boot command.

6. Log in as

root after boot completes.

7. Unmount

/dev/hda3.

[root@MergePoint5224 /]# umount /dev/hda3

8. Run the create_cf command with the --doformat option.

The following command example shows entering the

--factory_default argument to restore

the factory default configuration files at the same time.

CAUTION: Be aware that the --doformat option erases the Flash memory and installs the boot image into the

image1 area. See Options for the create_cf command on page 205 for other options.

The following text appears when the operation completes.

9. Enter the

reboot command to restart the unit.

Options for the create_cf command

Administrators can use the create_cf command when troubleshooting problems with the boot

image, as described under To upgrade to a boot image from a network boot: on page 204. Use it

carefully as described in this section.

CAUTION: Only use the --doformat option to save the image that is currently in RAM into the image1 area, but

be aware that this option reformats all Flash partitions while saving the image.

NOTE: Use the --image[1|2]option to save the image that is currently in RAM into a specific image area, without

reformatting the partitions that contain the other image.

=> printenv

ipaddr=192.168.45.29

serverip=192.168.45.127

bootfile=fl2222222.bin

=> net_boot

[root@MergePoint5224 /]# create_cf --doformat --factory_default

Creation of image

<N> completed.

...

[root@MergePoint5224 /]# reboot

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 239 240

Nessun commento

Cyclades AlterPath BladeManager Manuale delle Istruzioni Pagina 219