Cyclades AlterPath BladeManager Manuale delle Istruzioni Scaricare il pdf (Pagina 23)

Chapter 2: Basic Installation Procedures 9

To rack mount the SP manager:

1. Attach the right bracket to the right side and the left bracket to the left side.

a. For each bracket, insert four screws through the bracket’s holes into the appropriate holes

at either the front or rear.

b. Use a Phillips screwdriver to tighten the screws.

2. Use the appropriate mounting hardware to mount the SP manager to the rails.

Making Public Ethernet Connections

The primary public Ethernet port must be connected to an Ethernet switch, router or local area

network (LAN) that provides Internet access, to enable remote configuration and remote access to

target devices.

The secondary public Ethernet port can be optionally used in the following ways:

• To connect to a second network

• To connect to the same network as the primary Ethernet port for redundancy in case of failure

of the primary port (Ethernet failover or bonding)

With a failover configuration, the administrator must take additional steps to enable failover.

For more information, see Public Ethernet ports on page 39.

One or more optional Ethernet PC cards may be inserted and configured to support the following:

• A second, third or fourth network (depending on how the two public Ethernet ports

are configured)

• If failover is configured, a second, third or fourth failover interface

You can use the RJ

-45 to RJ-45 Ethernet CAT 5 cable shipped with the SP manager or an

off

-the-shelf CAT 5 or greater cable (such as CAT 5e) to connect the Ethernet ports to Ethernet

switches, routers or local area network (LAN) ports.

To make a public Ethernet connection:

1. Connect one end of a standard Ethernet cable to an Ethernet switch, router or LAN port.

2. If you are making one Ethernet connection, connect the other end of the cable to the primary

Ethernet port on the SP manager.

3. If you are setting up Ethernet failover, connect a second cable from the same network to the

secondary Ethernet port.

4. If you are using an optional Ethernet PC card on the SP manager, connect a cable between one

of the Ethernet connections listed in step 1 to the PC card.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 239 240

Nessun commento

Cyclades AlterPath BladeManager Manuale delle Istruzioni Pagina 23